[Elecraft] Very Dissatisfied With Elecraft Support

[Brian Lloyd]

> 	I can understand your frustration, but there may be a simplier
> solution. The K2 comes with the parts to make a simple RF probe: 1N34A
> diode, .01 uf cap, 47 M ohm resistor and a length of RG-174 coax. You
> should be able to order all of the parts from Elecraft, including the
> small PC board that is used - part number E100079 (it's also used as a
> spacing tool for mounting the front panel switches). The instructions
> are on page 9 of Appendix E in the K2 manual that can be downloaded  
> from
> the Elecraft web site.

For that matter, someone who has already built their K2 and used a  
'scope instead of the RF probe probably has all the bits lying around  
and would send them to Jon if he asked.

--

73 de Brian, WB6RQN
Brian Lloyd - brian HYPHEN wb6rqn AT lloyd DOT com