[Elecraft] Heil Proset Plus and K3

[Bruce McLaughlin]

Yep.  Don explained that and it makes sense.  I don't know why anyone would
want to vary the bias but then again, some folks like to be different.  I'm
still having a little trouble interpreting some of the menus.  I tend to
read them quite literally.

Bruce - W8FU

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ken K3IU
Sent: Thursday, May 15, 2008 7:05 PM
To: Bruce McLaughlin
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Heil Proset Plus and K3

Hi Bruce:
The High (H) and Low (L) refer to the gain in the circuit, not the bias 
level. Tap the display button when you are in the MAIN: MIC SEL mode to 
read what the "help file" says.
73,
Ken K3IU

Bruce McLaughlin wrote:
> I am using the Proset marked "IC" which came from Elecraft with my new K3.
> Inside the instructions said it was for the K2 but I think that was
printed
> before the K3 was around.  It has a short Kenwood (red) 8 pin adaptor.  It
> works fine plugged into the front mike connector with the mike bias turned
> on.  Currently the bias is set to high but I understand it will also work
> with the bias set to low.
>
> Bruce - W8FU
> Advice/comments regarding setup appreciated. 
>   
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 269.23.16/1445 - Release Date: 5/15/2008
7:25 PM