[Elecraft] Heil Proset Plus and K3

[Bruce McLaughlin]

I am using the Proset marked "IC" which came from Elecraft with my new K3.
Inside the instructions said it was for the K2 but I think that was printed
before the K3 was around.  It has a short Kenwood (red) 8 pin adaptor.  It
works fine plugged into the front mike connector with the mike bias turned
on.  Currently the bias is set to high but I understand it will also work
with the bias set to low.

Bruce - W8FU

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of John AK4Z
Sent: Thursday, May 15, 2008 4:31 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Heil Proset Plus and K3


Is anyone using a Heil Pro Set Plus IC with a HC-4 and iC electret element
with their K3? How did it play? I understand that a Heil Kenwood adaptor
(red) is needed to interface with the 8-pin microphone connector on the
front of the K3. Is rewiring of the 8-pin Kenwood connector required? 
Advice/comments regarding setup appreciated. 
-- 
View this message in context:
http://www.nabble.com/Heil-Proset-Plus-and-K3-tp17261851p17261851.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 269.23.16/1445 - Release Date: 5/15/2008
7:25 PM