[Elecraft] Ke: Programming SWT and SWH options

[Thomas Norff]

Hi Bob,

i'm using these commands in macros:  !! K31;  is needed to enable the
command extensions !!

--------
To all who are missing a easy way to configure the RX/TX equalizer.
Based on the available tools i would use the Macros to set the RX/TX
equalizer for different needs.

An short example (pls don't type in the comments...):

	AI0;			no response
	K31;			is needed to use the SWT command
	MN008;		or 009 to select RX / TX equalizer
	SWT53;		tab CLR => set all values to 0dB
	SWT11;		tab A/B => select first frequency
	
				11 A/B  (1) => select 50 Hz
				12 REV  (2) => select 100 Hz
				13 A>B  (3) => select 200 Hz
				24 PRE  (4) => select 400 Hz
				27 AGC  (5) => select 800 Hz
				29 XFIL (6) => select 1200 Hz
				33 NB   (7) => select 2400 Hz
				34 NR   (8) => select 3200 Hz

	UP;			to set +1 dB
	    or					up to 16 times each !!
	DN;			to set -1 dB
	MN255;		exit the menu
	K30;			back to default (optional)
	

This one will set TX-EQ to -3/-2/0/0/0/+2/+3/+3  (this is only an example...
pls don't ask why....)

AI0;K31;MN009;SWT53;SWT11;DN;DN;DN;SWT12;DN;DN;SWT29;UP;UP;SWT33;UP;UP;UP;SW
T34;UP;UP;UP;MN255;K30;
	
-------- 

You can use the K3 Utility and test these commands in the 'command
tester'...

73 Thomas, DM7TN

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Bob Tellefsen
Sent: Wednesday, May 14, 2008 10:53 PM
To: Reflector Elecraft
Subject: [Elecraft] Ke: Programming SWT and SWH options

The programmers' reference says that the SWH and SWT functions are not
implemented yet.  However, I've been told that preceding such a command with
K3; should make them work.  It hasn't for me, so I'm asking if anyone else
has attempted to get these functions to program yet?  Were you successful?
If so, what did you do to make it work?

Thanks and 73
Bob N6WG

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com