[Elecraft] no transmit on K3

[n4lq]

Sometimes one of the front panel connector pins don't line up and that 
breaks the mic connection. If you have a computer mic hand, plug it into the 
rear panel, change the menu and see if that works. That would be rP.L 
Bias...in the menu. This will narrow down the problem.
Steve Ellington
N4LQ at insightbb.com
----- Original Message ----- 
From: "Marin QRP" <marinqrp at gmail.com>
To: <elecraft at mailman.qth.net>
Sent: Sunday, May 11, 2008 2:14 PM
Subject: [Elecraft] no transmit on K3


> I'm trying two different mics to transmit with.
> One is a Kenwood hand mic from a Kenwood 570D
> and the other is a Heil Pro Set Plus with an 8pin
> Kenwood mic adapter.  I haven't had any luck when even
> trying to set up my levels for transmitting.  I cannot get any bar
> to show up or move on the ALC or Compression when keying down.
> I have tried with the compression as high a 30 and the mic gain as high
> as 60 but no movement, whether in TX Test or regular TX mode.
>
> I feel like I am forgetting to change one setting somewhere,
> if that is what the problem is.
>
> I put the K3 together myself and don't know if something could
> have been done wrong there, but after looking again and again
> in the manual, I just don't know what else to try.
>
> Any suggestions, even to go and check basic settings will be
> appreciated.  Please reply offline.
>
> Thanks
>
> Rem
> k6bbq
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.23.15/1426 - Release Date: 5/10/2008 
11:12 AM