[Elecraft] K3: SSB + CW (Auto CW) and VOX/PTT

[Alexandr Kobranov]

Just to clarify what I suppose to be better:

If SSB + CW (Auto CW) active, let it is valid only for SSB mode and on 
CW mode settings of PTT (PTT or VOX-QSK semi or full) will be considered.
Then when I am only on CW I do not need to go to SSB -CW to disable 
QSK when need PTT only behaviour.
There is no problem with dealys there is problem that in system which 
rely on PTT only you can cause some problems in CW mode by touching 
the Key as no information about QSK active (caused by SSb +CW 
settings) is dispalyed (my feeling).

73!
L. -dst-
K3/10 #727


Alexandr Kobranov napsal(a):
> Hello,
> 
> just tested that in my case if I have AutoCW active (CONFIG:CW WGHT and 
> tap '1' until you see SSB +CW) there is all the time CW QSK active!
> If I am in SSB mode and PTT active (NO VOX) when key is touched TX is 
> going to be activated.
> In CW mode the same - no VOX, no QSK but all the time like QSK active, 
> no VOX label on display.
> There is need to follow up the settings - if PTT is required there could 
> not be any QSK in any mode.
> When Auto CW is off, it seems to be ok - following PTT settings.
> Having latest FW and straight key connected to key on rear panel.
> 
> Can you please anybody else test this if it is some bug or is time to 
> reload FW here?
> 
> Thanks,
> Lexa, -dst-
> k3/10 #727
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>