[Elecraft] 100w amp plate

[Ken K3IU]

Hi again, Mike:

I didn't notice that there was a finished side and an unfinished side on 
the fan panel if that is what you mean by "Amp Plate." Both sides were 
about the same as I recall. Can you install it per the manual with what 
you call the "finished side" perhaps facing a direction other than what 
you tried??? If so, then you can press on with the installation and if 
you have defective paint on the fan panel, I'm sure that Elecraft will 
send you a replacement.

73,
Ken K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Mike Kasrich wrote:
> Has anyone else received an amp plate that was cut backwards?  The 
> pixs show the plate with fans attached with the lead fed through the 
> upper right.  I cant orient the slots with the finished side out  with 
> the plate that came with the kit. in that direction.
>
> Just curious.  Up until this point the build and Calibration was going 
> smooth now Im at a stand still.
>
> Mike/aj9c