[Elecraft] tune pwr

[Mike N8XPQ]

Yes,

Hold down the menu key to enter the config menu. Rotate VFO B knob until you
find TUN PWR set this setting to your desired tune power. I hope this helps.

Mike N8XPQ


Todd Ruby wrote:
> 
> I have just put the K3 on the air for the first time after  
> downloading all firmware upgrades. When I hold TUNE pwr is at 0 and  
> rotating the PWR ctrl gets it to a desired output just fine. when i  
> go to retune it is back at 0 watts and I have to rotate the PWR knob  
> each time. What is the way to have the PWR be at least set to where  
> it was previously?
> 
> tnx in advance
> 
> 
> 
> 
> 73
> de
> todd
> WB2ZAB
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 


-----
Mike Koetje N8XPQ
-- 
View this message in context: http://www.nabble.com/tune-pwr-tp17152193p17152559.html
Sent from the Elecraft mailing list archive at Nabble.com.