[Elecraft] KAT2 INSTALL - VOLTAGE AT U4, PIN1

[MTcja]

Don:

Thanks again.  Good news.  And thanks for the hint I do have the k60xv to
install so this is a big help.  I am kind of going by guess and by golly on
what order I install things.  I have started with the KAT2 and had planned
to move to the SSB2, but I may do the 160m accessory first.  Suggestions
always appreciated.

73's
Chris

Don Wilhelm wrote:
> 
> Chris,
> 
> Unless you are really careful with your DMM leads and have zeroed your 
> DMM, *any* reading of .001 volts (or even up to .003) can be considered 
> zero under normal conditions because it is likely noise being coupled 
> onto the DMM leads from sources unknown.
> 
> So, yes, that is close enough to zero.
> 
> Additional hint: if you are ever going to install the K60XV, use a 470 
> ohm resistor at the R6 location rather than the 47 ohm value.  If you 
> have the K60XV in hand, you will find an extra 470 ohm resistor just for 
> that purpose packaged with the kit.
> 
> 73,
> Don W3FPR
> 
> MTcja wrote:
>> After listening for a while and reviewing basic and advanced operation I
>> am
>> now beginning the install of the K2 accessories.  For the KAT2 I am
>> getting
>> .001 V at U4/PIN 1.  Is this "close enough" to zero?  If not, please
>> advise
>> the best way to trace back the origin of this voltage.  BTW, in TUNE I am
>> at
>> 3.8.  Thanks.  
>>   
>>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://www.nabble.com/KAT2-INSTALL---VOLTAGE-AT-U4%2C-PIN1-tp17115482p17116537.html
Sent from the K2 mailing list archive at Nabble.com.