[Elecraft] ANYONE HAVE SECRET TO ALIGNING?CONNECTING K# FRONT PANELTO MAAIN RF BOARD

[Russ]

George;

Look at Fig 51 at the top of pg 37.  You may be having a problem with screw 
on the 2D connector hitting the DSP board as shown in the right picture.  I 
had to remove the screw as suggested to install the FP.  Also there was a 
slight misalignment in the pins on the two connectors but I was able to 
shift the board a bit to get the connectors on.

Russ, N3CO

----- Original Message ----- 
From: "George Sereikas" <sereik at bellsouth.net>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, May 07, 2008 8:42 AM
Subject: [Elecraft] ANYONE HAVE SECRET TO ALIGNING?CONNECTING K# FRONT 
PANELTO MAAIN RF BOARD


>I am building my K-3 and have come to the point(p 36 in instructions) 
>where I am attempting to mount the Front Panel. I can't seem to get it  on. 
>I'm afraid to put too much pressure for fear of breaking  something. Any 
>good ideas on this from someone who has already done  this?
>
> Thanks!
>
> George
> K2WO
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
> -- 
> Internal Virus Database is out-of-date.
> Checked by AVG. Version: 7.5.518 / Virus Database: 269.23.6/1404 - Release 
> Date: 4/29/2008 6:27 PM
>
>