[Elecraft] ANYONE HAVE SECRET TO ALIGNING?CONNECTING K# FRONT PANELTO MAAIN RF BOARD

[David Yarnes]

George,

It is highly probably that your problem is the microphone connector.  It's a 
tight fit, and may have to be reamed a bit.  Try wiggling the panel around 
that area and see if that isn't where it is binding up.  Mine was tight, but 
didn't have to do any reaming of the hole.  It just took a little localized 
jockeying to get it to slip over the connector.

Dave W7AQK


----- Original Message ----- 
From: "George Sereikas" <sereik at bellsouth.net>
To: <Elecraft at mailman.qth.net>
Sent: Wednesday, May 07, 2008 5:42 AM
Subject: [Elecraft] ANYONE HAVE SECRET TO ALIGNING?CONNECTING K# FRONT 
PANELTO MAAIN RF BOARD


>I am building my K-3 and have come to the point(p 36 in instructions) 
>where I am attempting to mount the Front Panel. I can't seem to get it  on. 
>I'm afraid to put too much pressure for fear of breaking  something. Any 
>good ideas on this from someone who has already done  this?
>
> Thanks!
>
> George
> K2WO
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>