[Elecraft] MCU 1.88 / DSP 1.70

[G4ILO]

Stewart G3RXQ wrote:
> 
> Wayne and Team,
> Many thanks for your sterling efforts on the latest firmware.
> 
> After sorting out an upload problem the end result is a radio
> which as some might say in |England "is cooking with Gas" !
> 
> I can't comment the number of changes made to modes such as AM, FM
> and Data which are not my primary  interest, but the ones that
> effect CW and SSB are great.
> 
> The SSB transmit performance now seems about optimal, with the
> COMP and ALC working as they should. There are, however more
> artifacts when using Monitor on SSB. In addition I also appreciate
> the increased range of the Wattmeter HP settings.
> 
> On the receive side the DSP filter setting appear to be more
> stable with band change etc, but I still have the intermittent RX
> loss after TX.
> 
> All in all a great job, keep up the good work...
> 
> 
I noticed that the LINE IN input is less sensitive with this version. I had
to increase the output at the computer end. Not a problem, but I did wonder
what was wrong for a moment.

However, I'm still finding that in DATA A mode when I feed in a pure tone
I'm only getting 3W when I have requested 5W out, or 7W when 10W is set.
Other constant carrier modes like CW and FM do give 5W out.

-----
Julian, G4ILO  K3 s/n: 222 K2 s/n: 392
G4ILO's Shack: www.g4ilo.com
Zerobeat Ham Forums: www.zerobeat.net/smf
-- 
View this message in context: http://www.nabble.com/MCU-1.88---DSP-1.70-tp17060678p17066967.html
Sent from the Elecraft mailing list archive at Nabble.com.