[Elecraft] K3 FIRMWARE UPDATE: MCU 1.87, DSP 1.69 (Finally!)

[Dr. Werner Furlan]

hi Wayne,

On 4 May 2008 at 11:48, wayne burdick wrote:

> > Will TX EQ be made mode and/or input dependent?  Setting TX EQ
> > for voice screws up the audio response for digital mode (AFSK A and
> > DATA A) operation.  The same is true for RX EQ.
> 
> I believe both RX and TX EQ are bypassed in DATA modes. If not, they
> should be. I'll mention this to Lyle.
> 
> Per-mode settings are on the list, too.

I have two different micophones, one needs heavy TX EQ correction, the 
other one is good with neutral settings. Is it possible to store a profile for 
this? Settings per input would not help in my case, because I connect both 
microphones on the rear connector. 

You will ask, why do I use a different microphone? The reason is I cannot 
bear the good one (headset) for a long time, and sometimes have to change 
it because my ears hurt. And the small headset which needs correction is 
the choice for portable use.

73! de Werner
OE9FWV





--  
 I have seen the truth and it makes no sense.



PGP-Key: <http://www.qsl.net/oe9fwv/furlan.asc>
Fone +43 5522 75013
Fax +43 820 555 85 2621
Mobile      +43 664 6340014