[Elecraft] Imminent new K3 firmware will require Version 1.1.4.1 of K3 Utility

[Dick Dievendorff]

A new K3 firmware revision is going to be published in the very near future.

In order to install this new firmware in your K3, you must use the current
version of the K3 Utility, version 1.1.4.1, which is available on the
Elecraft web site at 

http://www.elecraft.com/K3/k3_software.htm

Earlier versions of the K3 Utility may NOT be used to load the new firmware.


There is a new "Front Panel Flash" (FPF) loader required to load a new
"Front Panel Flash" file that will be part of the new firmware.

K3 Utility Version 1.1.4.1 retains the ability to install earlier K3
firmware versions.

You may determine the version of your K3 Utility by viewing the "About K3
Utility" Help menu item.

73 de Dick, K6KR