[Elecraft] K3: TX INHIBIT error

[Ken K3IU]

There is an item in the CONFIG menu called "TX INH" that you should 
check... It should be "OFF" unless you have set something special up.

73,
Ken K3IU

ab2tc wrote:
> Hi,
>
> K3 #82 has a new home here in Central New York. I am having a blast with it
> in the WPX contest.
>
> It has developed a minor problem. After a while, the TX icon below the [A]
> display label sometimes starts flashing and the radio will not transmit. If
> I use the XMIT button to key it, the message TX INHIBIT is shown in the B
> display. Turning radio off and back on instantly cures the problem (haven't
> found any other way). I doubt if anything is overheating, I am only using
> SSB with a relatively low duty cycle.
>
> Note that the radio is *not* in TEST mode as suggested by some at the Yahoo
> forum. The symptoms are different as the radio will not enter transmit mode
> at all. I hope this is not anything serious. It does look like this will
> only happen when the radio has been on for several hours, not necessarily
> transmitting a lot.
>  
> Knut - AB2TC
>