[Elecraft] K3 VFO rubber grip

[Mike Scott]

Thanks for the replies on getting my rubber grip off of my VFO A knob. I
needed to get it started with a wooden tool. I remember when I put the grip
on in the original build I thought it was tight. I was able to remove it
early on to adjust friction. This time it was much more difficult. Judging
from other replies I think mine is tighter than others. Anyway I am good to
go with a tightened VFO A encoder shaft.

Mike Scott - AE6WA
Tarzana, CA (DM04 / near LA)
K3-100 #508/ KX1  #1311