[Elecraft] re: K3: Filter settings when changing bands

[wayne burdick]

Ed,

Thanks for identifying a way to reproduce this behavior, which had 
proven elusive. Using your method, I've now found the cause and fixed 
it, and it'll work correctly in the next firmware release.

73,
Wayne
N6KR

  > Say I am on 12M USB.  Filter width is set to 2.7.  I switch to CW,
  > set filter to 400.  Everything is fine.  I switch bands to 17M CW by
  > tapping the band down twice fast.  Filter is set to 2.7, so I change
  > it to 400.  I switch back to 12M, both USB and CW filter settings are
  > correct, I can toggle between the two modes.  I then go from 12M USB
  > back to 17M CW by tapping band down twice.  The filter on CW is back
  > again to 2.7.  Why wouldn't it remember the last setting I had for
  > CW?


---

http://www.elecraft.com