[Elecraft] KX1 - 7 displays briefly; then just the single lower left vertical LED segment flashes.

[Bill Johnson]

Nicolas,

Sounds like a loose connection or solder/wire causing the issue.  I highly
recommend going through the board and looking closely at all of the
components and solder connections.  Every problem I ever had was basically
one of solder connections.  Either I missed one or got interrupted and
didn't finish one correctly.

Good luck I know you will figure it out. Don't forget to put it aside and
give it a rest every now and then as well.  It works great to take a break.
Otherwise something so simple can become quite frustrating, at least it does
for me.

72,

Bill 

K9YEQ
K2 #35, K2 # 5279, KX1 #35, Mini Modules, etc.  



-----Original Message-----


KX1 Build.

vertical LED segment flashes.
I have tried a reset but as soon as the switches are released the same Led 
segment still just flashes.

Is there anything else I should be checking?
Any suggestions appreciated as my planned /P building attempt has now 
paused, and I was so close to getting the RX working!

Please reply to nicolas at jetblackjelly.com as I only get the daily digest.

Thanks Again!!!!

Regards
Nicolas
www.m1hog.com