[Elecraft] CW Decode

[G4ILO]

Frank MacDonell wrote:
> 
> Can anyone recommend software for CW decode. I'm just learning CW and
> I am concerned about my ability to copy. Any suggestions? Thanks.
> 
I haven't found any software decoder that works well enough on hand sent
Morse to rely upon.

The best CW decoder I personally have found is a Linux program, gMFSK.

On Windows, I found the program CWGet to be the best. There is also a free
one you can get from here: http://www.hotamateurprograms.com which is pretty
good, if you can live with the user interface. I've seen a lot of reports
that MRP40 http://www.polar-electric.com/Morse/MRP40-EN/ is the best of all
under Windows but I have never tried it.

If you buy a K3 then of course it has a built in morse decoder, though I'm
not sure it is quite up to the standard of the best PC programs.

-----
Julian, G4ILO  K3 s/n: 222 K2 s/n: 392
G4ILO's Shack: www.g4ilo.com
Zerobeat Ham Forums: www.zerobeat.net/smf
-- 
View this message in context: http://www.nabble.com/CW-Decode-tp16224545p16227841.html
Sent from the Elecraft mailing list archive at Nabble.com.