[Elecraft] K3 Configuration

[David Ferrington, M0XDF]

I think if you set CONFIG: KPA3 = PA BYP
and set PWR below 12w that will work.

however, SSB has been greatly improved as of late - ensure you are  
running latest firmware and try that first.
-- 
"There is no limit to what you can accomplish if you don't care who
gets the credit." --Ronald Reagan

On 22 Mar 2008, at 10:02, Ian J Maude wrote:

> Hi all,
> Can I redo the K3 config on 5W with the PA physically in place or do  
> I need to remove it?  I am no at all happy with the output power so  
> I want to go through the config again.  Like others, I find that on  
> SSB, the output does not peak at all well.
> TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I  
> have seen in other reports.