[Elecraft] Re:Mike plug for K2

[Robert Tellefsen]

John
I had a similar problem with my mobile mic.
Where the cable comes out of the mike plug,
I put several layers of heat shrink tubing to
make a boot of sorts.  The inner tubing piece
was longest, thenext a bit shorter, and the last
shorter yet.  This made a supportive but
flexible boot on the cable and prevented a
lot of trouble.  I did not heat treat the shrink
tubing, but left it as it came from the box.
73, Bob N6WG


----- Original Message -----
From: <Jferg977 at aol.com>
To: <elecraft at mailman.qth.net>
Sent: Friday, March 21, 2008 8:09 AM
Subject: [Elecraft] Re:Mike plug for K2


> I just recovered from the wild goose chase instigated by a parted
ptt
> connection within the RS mike plug which I installed on the old Icom
VHF  mike which
> I've been using quite effectively on K2/100 5087. Can anyone
recommend
> another plug which has a more extended spring or flexible tube to
help  isolate the
> plug connections from cord-flexing?
>
> AI4TO,  John Ferguson  M/V Arcadian  Marathon,  FL
>
>
>
> **************Create a Home Theater Like the Pros. Watch the video
on AOL
> Home.
>
(http://home.aol.com/diy/home-improvement-eric-stromer?video=15?ncid=a
olhom00030000000001)
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com