[Elecraft] K3 SSB Noise Reduction

[Stewart Baker]

With the K2 DSP I seem to remember that there was a parameter to 
normalise the gain between NR In and Out. Maybe the same could be 
done with the K3 DSP ?

73
Stewart G3RXQ
On Thu, 20 Mar 2008 13:33:10 -0700 (PDT), F5VJC wrote:
>
> This is my experience too with the K3 NB.
> I believe it is normal, but question why the AF level can not be 
auto
> adjusted to offset this reduction with the NB engaged.
>
>
> mark roz wrote:
>
>> Can anybody explain to me why with NR engaged  SSB signal 
drop's in volume
>> significantly. AF volume has to be readjusted every time the NR 
is turned
>> ON and than again when is turned off.
>> NR is on F1-1.
>> I don't believe that this is normal.
>> Thanks,
>> Mark
>>
>>
>> 
__________________________________________________________________
__________________
>> Be a better friend, newshound, and
>> know-it-all with Yahoo! Mobile.  Try it now.
>> http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>>
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>>
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>
> -----
> 73, Deni F5VJC
>
> K2 1188   K3  325
>
> For a Ham Radio friendly holiday in France...
> Visit www.mycottageinbrittany.com