[Elecraft] [K3] max input voltage on Ant 1 or 2

[Brett Howard]

I had a gen that would give me 1mV and I found that it produced a signal
that was so wide there was no way to accurately zero up on it.  But if I
turned the output of my generator off I found that there was enough
cross talk across the output relay to generate a lot of signal into the
radio.  So its quite possible that you can pull this off.  Or if all
else fails just put a terminator on your generator and run a cable out
of it (just a single wire).  then you can run a wire into the rig and
you can then couple these wires more or less to vary the amount of
signal that you want/need.


On Wed, 2008-03-19 at 23:10 +0000, David Ferrington, M0XDF wrote:
> I can't find this in the spec although I expect its there
> what is the max input voltage on Ant 1 & 2?
> I have a ref osc that gives 5MHz at ~ 5mV, I'd like to use this to do  
> a ref cal by direct connection to ant 1 or 2