[Elecraft] K2 - Initial Alignment & Test Part 1 - Issues

[John Hoaglun]

Maybe there is someone on the list that has been through this issue and 
can lend me their insight.

I am on page 42 which is the Alignment and Test Part 1 section of the 
assembly notes.

My relays all click as expected, I get the Elecraft message and then I 
get a  message on the screen: 0250.33r and at the same time
"VFO B, RIT, and XIT" are all flashing. I am expecting 7100.00c 
according to the book.  The "0250.33r" message will change as the RIT is 
adjusted.   --I don't see any references in the troubleshooting to this.

The other weird thing is that when I turn the VFO the display does not 
change.

The other initial tests seem fine. (Voltages, relays, etc)

I am going to hold off going any further until I understand why the 
message does not look right for where I am in the book.

Any thoughts or ideas?

Thanks, JH

-- 

John Hoaglun
NG0R - EN25
http://www.hoaglun.com