[Elecraft] wattmeter calibration
Paul Christensen
w9ac at arrl.net
Sun Mar 16 09:38:47 EST 2008
I should also state that when I was calibrating my K3 wattmeter, I was
looking at three wattmeters in series -- an LP-100, Array PowerMaster, and
Alpha 4510. Each wattmeter reads within 2% of each other into a Bird
TermaLine load.
Paul, W9AC
----- Original Message -----
From: "Paul Christensen" <w9ac at arrl.net>
To: <Elecraft at mailman.qth.net>
Sent: Sunday, March 16, 2008 10:34 AM
Subject: Re: [Elecraft] wattmeter calibration
> Todd brings up a good point. I ran out of range while calibrating at the
> 5W and 50W level.. I got pretty close but ran out of adjustable range.
>
> Also, I am confused as to what is happening with the RF Gain Calibration
> procedure. The routine calls for setting power level at a pre-set level
> and running through the bands. But how is the value adjusted and saved ?
> And if TUNE is depressed later, are the saved values affected? Or, is it
> the fact that the RF Gain procedure is conducted while in CONFIG that the
> those settings are saved? It's just a very strange procedure and I don't
> understand how a relationship is established between the displayed power
> and RF Gain setting during setup. Can anyone explain? Tnx!
>
> Paul, W9AC
>
>
> ----- Original Message -----
> From: "Todd Ruby" <rubywine at verizon.net>
> To: <Elecraft at mailman.qth.net>
> Sent: Sunday, March 16, 2008 10:09 AM
> Subject: [Elecraft] wattmeter calibration
>
>
>>I finished assembly except for PA last week and went through the
>>calibration sequences. I am not able to have the wattmeter on the K3
>>match the output reading on the Bird wattmeter. Any suggestions?
>>
>>
>>
>>
>> 73
>> de
>> todd
>> WB2ZAB
>>
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>>
>> --
>> No virus found in this incoming message.
>> Checked by AVG. Version: 7.5.519 / Virus Database: 269.21.7/1329 -
>> Release Date: 3/14/2008 12:33 PM
>>
>>
>
More information about the Elecraft
mailing list