[Elecraft] PA Temperature Sensor problem

[aa1o]

Mark,
sounds as if you haven't enabled the PA. check the config menu KPA3 should 
be set to nor (not "io nor")
-Bill AA1O

----- Original Message ----- 
From: "MARK HAMPTON" <area.x1 at btinternet.com>
To: <elecraft at mailman.qth.net>
Sent: Saturday, March 15, 2008 3:55 PM
Subject: [Elecraft] PA Temperature Sensor problem


> Hi all,
>          #579 went together smoothly but I have a little problem with 
> setting the PA sensor temperature.     I had no problem with setting the 
> front panel temperature.  However, I moved on to do the PA one and moving 
> the VFO dial does absolutely nothing - its 2 'dashes' where the 
> temperature should be.    I haven't updated the firmware yet so that could 
> possibly be the problem though is there any other possible problem?
>
> Thanks, Mark M5MDH
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com