[Elecraft] K3 RF REF CAL Procedure

[Greg]

Paul.  Please check your errata sheet.  This calibration method is not yet
implemented in the firmware.  Best method to use right now is to use WWV
until the FW is ready for method 3.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Paul Christensen
Sent: Friday, March 14, 2008 7:16 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 RF REF CAL Procedure


Trying to get my K3 to go into Reference Oscillator Calibrate routine using
Option
#3 (temp compensation).  I have "Tech MD" enabled [ON], but I cannot toggle
out of "REF CAL" to get to "REF xxC."   It just stays on "REF CAL"
regardless of
tapping the "1" button on the numeric keypad.  Latest K3 firmware is
installed.   Ideas?

Paul, W9AC

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com