[Elecraft] K2/100 resistance checks

[Ken, KA0W]

+/- 5% or even 10% should be fine for any measurement
of resistance, capacitance, inductance, and etc. More
accurate measurements would be beyond the capability
of most Flukes or other meters.

Have fun!

Ken, KA0W



 
--- paul <pj at pcrentals.com> wrote:

> Just finishing up the KPA100 add on kit and doing
> the final resistance 
> checks.
> 
> On Q1 base to ground, I measure 11.5 ohms instead of
> the recommended 12 to 
> 16 ohms.  I get the same on Q2 base to ground.  All
> other measurements are ok.
> 
> I am using a Fluke meter and it is accurate.  Are
> these measurements ok?  
> Can I round up 11.5? :)
> 
> Paul
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft   
> 
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>