[Elecraft] K3: Loose Headphone Washer

[Terry Schieler]

No, thank YOU Carl.  I had several emails that were beginning to make me
think I was hearing things, or made a serious mistake.  I could possibly
tighten the knurled ring a wee bit more but it already appears to be
compressing the front panel slightly.  I only used my fingers as directed,
but I worked hard at getting most of the washer rattling taken care of.  The
rest of the physical fit of the housing and components is SO darn good that
this has become a head scratcher.

Terry, WØFM

K3/100 #474



-----Original Message-----
From: Carl Clawson [mailto:carlclawson at verizon.net] 
Sent: Sunday, March 09, 2008 12:47 PM
To: elecraft at mailman.qth.net
Subject: RE: [Elecraft] K3: Loose Headphone Washer

Thanks, Terry! I'd been wondering what was rattling in my K3 but hadn't
found it yet. That was it. The connector was hanging up somewhere along its
length. I gently wiggled it and heard a small click as it slipped through.
Then I was able to tighten the knurled ring a little more and now it's fine.
I couldn’t tell if was hung up against the front panel itself or the front
panel board where it passes through. Probably the panel, maybe had a little
burr or a fleck of paint or something catching against a thread.

73, Carl WS7L
K3 #486 QRV March 3

> 
> Has anyone else experienced a rattle where the thick headphone washer
> (used as a spacer) between the K3 headphone jack and front panel doesn't
> quite fill the void
> 
> Terry, WØFM
> 

No virus found in this outgoing message.
Checked by AVG. 
Version: 7.5.518 / Virus Database: 269.21.7/1322 - Release Date: 3/9/2008
12:17 PM