[Elecraft] Firmware 1.75...WOW!

[Greg]

Hi Bob.

I set ALT1 with  filter FC of 1000 Hz and about 700 Hz wide.  I used this
for most digital modes other than FSK-D or AFSK.  I set ALT2 with a LO of
900 Hz and a Hi of 2.4 kHz for SSTV.  Now all I have to do is recall these
on demand when needed.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Bob Evans
Sent: Sunday, March 09, 2008 6:13 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Firmware 1.75...WOW!


I don't know why I get pleasantly surprised by all the neat little goodies
tucked into these revisions, but it is so nice to see improvements and new
features showing up on the K3 hardware platform through firmware revisions.
Even though I like to think of myself as a CW only op, the SSB TX
adjustments sure help.  I like the fact that my DSP filter now goes in
100kHz steps rather than 200kHz steps above 2000kHz.  I'm still trying to
find a use for Alt1/Alt2, but at least it is there when I think of a good
use.  And the rig just sounds better (that's a qualitative technical term)
too.

Thanks Elecraft!!

Bob K5WA
K3 #234
K2 #4687
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com