[Elecraft] K3 Data Overshoot

[Greg]

Data spikes will happen if you do not set up correctly for data mode.
Please see the Operating Tips page on the Elecraft website.  If you over
drive with either the soundcard or the Line In control using MIC gain, you
will get spikes.  But if you follow the setup tip you should not see any.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Toby Deinhardt
Sent: Sunday, March 09, 2008 4:37 PM
To: Mike Harris
Cc: Elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 Data Overshoot


Hi Mike,

I've not seen exactly what you are reporting, but I have seen similar
behavior in the present and the previous firmware versions. These I
reported to Elecraft. I suggest you send a detailed description to
<k3support at elecraft.com>.

In my case, the misbehavior which was the most similar to yours, were
power spikes when barely moving the PWR knob in SSB and using the
transverter 0dBm output for a 144MHz transverter.

Every little bit of information can help in the debugging process.

vy 73 de toby
--
DD5FZ (ex 4n6fz, dj7mgq, dg5mgq, dd5fz)
K2/10  #885
K2/100 #3248
K3/100 #67
DOK C12, BCC, DL-QRP-AG, JN58td
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com