[Elecraft] K3 - RX Problem after latest firmware update

[AB7R]

Stewart,

Try installing the new firmware again.  I just tried to recreate your report
and the radio performs as expected...no problem with RX after a transmit
with ALT1 set to 0.15 on the LO side.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Stewart Baker
Sent: Sunday, March 09, 2008 11:32 AM
To: Elecraft Reflector
Subject: [Elecraft] K3 - RX Problem after latest firmware update


I am not sure if there is an obscure problem after the latest MCU
and DSP update. Maybe others could check and see if it happens to
them ?

Any band on SSB if I have the DSP set to ALT1 with the Low Cut set
at 0.15 Hz , then after going onto transmit the receiver appears
to be dead. If I set the DSP to NORM by pressing the knob the
receiver suddenly bursts into life...
This happens whether there is any transmit audio or RF out.

73
Stewart G3RXQ
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.518 / Virus Database: 269.21.7/1322 - Release Date: 3/9/2008
12:17 PM

No virus found in this outgoing message.
Checked by AVG.
Version: 7.5.518 / Virus Database: 269.21.7/1322 - Release Date: 3/9/2008
12:17 PM