[Elecraft] K3 MCU 1.75 Firmware Revision

[Tom Hammond]

Hi Roy:

>The new NORM values ALT1 and ALT2 do not show up as I or II on the 
>display when saved.  Once the bandwidth has been saved into ALT1and 
>ALT2, holding down the NORM knob and turning it to the desired 
>bandwidth does not change the I or II icon in the display.  I 
>suspect this is because holding the I/II knob down has nothing to do 
>with the bandwidth memories entered and saved via the NORM knob.  In 
>other words, ALT1 and ALT2 are not the same thing as I/II.  I hope I 
>understand this correctly.  Roy Morris  W4WFB  K3 #323

I don't believe it was intended that the I/II reflect these new 
settings. I believe they may have reserved for the 'non-sticky' 
presets accessed by holding the WIDTH button.

73,

Tom  N0SS