[Elecraft] K3 TXCO calibration - method 3 not working?

[Don Wilhelm]

Paolo,

The only 'wrong' thing is that you did not heed the information in the 
Firmware section of the Errata sheet - which points out those things not 
yet available.  Method 3 is not yet implemented.  Use one of the other 
methods until the supporting firmware has been released.

73,
Don W3FPR

IK4YNG wrote:
> Hi all,
> when i try to calibrate my TXCO using method 3, i'm unable to proceed.
> I locate the CONFIG:REF CAL, but when i tap "1" (i mean, the key labeled 1
> in red) the name does not change to REF xxC; all i get is a A/B VFO flip.
>
> Where am i wrong?
>
> 73,
> IK4YNG Paolo, K3#517
>