[Elecraft] K3 USB/LSB mode selection

[Don Wilhelm]

Mike,

The sideband selections are not hard coded, but they are remembered per 
band.  You must set it up once and then the correct sideband will be 
remembered (until you change it).
If the sideband is not correct for a particular band, hold ALT and it 
will change.  SSB now works the same way as CW and RTTY modes (which 
also have sideband selection capability).
Yes, this is a relatively new thing.  Check the firmware release notes.  
I believe a compilation of the newer firmware features may be 
forthcoming, but in the meantime please read the release notes to see 
what the changes have been.

73,
Don W3FPR

Mike Scott wrote:
> Am I stupid or what, okay don't go there. 
> I went to 60M to listen to the channelized band. I went to select upper
> sideband and just how does one do that? My mode options are LSB, CW, Data,
> AM. 
> I haven't found anything yet in the operator guide to help other than I
> should be able to toggle to USB by tapping the mode switch. It just isn't
> there when I do it. The sideband selections seem to be hard coded by band.
>
> Mike Scott - AE6WA
> Tarzana, CA (DM04 / near LA)
> QRP-ARCI #12326/ K3-100 #508/ KX1  #1311/ Swan 350C
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
>