[Elecraft] K3 Owner's Manual - A couple typo error..

[Tom Hammond]

Oh for crying out loud, Tom... you give them a correction and then
SCREW IT UP YOURSELF!

CORRECTION TO BE MADE TO YOUR   K3 OWNER'S manual   NOT the K2 Manual.

Sorry guys.

Never claimed to be a good typist.

Thanks,

Tom

At 18:59 03/04/2008, BackForty at BlandRanch.net wrote:
>Make a correction to my "K2" Owner's Manual????????
>
>Chuck Bland
>NA6BR
>
>= = = Original message = = =
>
>Folks:
>
>Just to no one will go off in the wrong direction when attempting to connect
>to the K3's RS-232 port...
>
>On page 18 of the K3 Owner's Manual, The table associated with RS-232 shows:
>
>
>     Pin #      Description
>    1,6,8,9  Not used
>       2     RXD IN (data to PC from K3)
>       3     TXD OUT (data to K3 from PC)
>       4     DTR (see PTT and Keying, below)
>       5     Ground (RF isolated)
>       6     RTS (see PTT and Keying, below)
>
>Obviously, pin 6 can't be 'Not Used' AND RTS at the same time...!
>
>RTS should be assigned to pin 7, and pin 6 really is NOT USED.
>
>Please make a pencil correction to your K2 Owner Manual.
>
>73,
>
>Tom Hammond   N0SS
>
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com
>
>
>
>
>___________________________________________________________
>Sent by ePrompter, the premier email notification software.
>Free download at http://www.ePrompter.com.