[Elecraft] K3 RS232 Pin Assignment Error?

[Tom Hammond]

John:

I see that Greg responded directly to you on this.

161,

Tom
----------------

Thanks for catching this John.  We had another report of this today and the
manual will be corrected in the next revision.

Pin 6 should be listed as not used.  Pin 7 should be the RTS pin.

Don...Could you put this on the Wiki also?

Thanks

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of John Silva N3AM
Sent: Monday, March 03, 2008 7:26 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 RS232 Pin Assignment Error?


Page 18 of the K3 Owner's Manual (Rev C1, Nov 18, 2007) designates
RS232 pin 6 as RTS, but the EIA standard says pin 6 is DSR, and pin 7
is RTS.  Is this an error in the manual?

John N3AM

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
  http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
  http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com