[Elecraft] Strange behavior

[Gary D Krause]

Hi David,

I have the 10 watt version and I've noticed that mine jumps between the 
frequency and power display setting every once in a while.  It will also jump 
between frequency and keyer speed setting too.  It doesn't happen very often 
and when it does, I just ignore it.  I figure it's just a glitch.  All part of 
having computers and radios mixed together. :-)  I know that may not be a 
satisfactory answer but, I just don't worry about it since it doesn't affect 
how my K2 operates.  If the power output and keying speed were to change 
because, of it then I would be concerned.

Gary, N7HTS


On Thu, 26 Jun 2008 20:24:56 -0700 (PDT)
  "David N." <pkmaint at yahoo.com> wrote:
> Hello all
> My K2 has begun to flash back and forth between power reading and frequency. 
>When the power setting is above 10 watts KPA ON I assume.
> When you change the vfo it will flash between power and Freq sometimes.
> Also with the power display showing it only reads 68 watts flickering 69 
>watts. But it puts out full power. I assume it is in the KPA 100 but the only 
>thing that I can see that controls the KPA 100 on off is U1 So what does this 
>have to do with reporting? With KPA Off it operates as suppose to. My K2 is 
>going to be the cw rig for our club field day. 3A NFL
> 
> Thanks
> David KR4OW
> 
> 
>      
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com