[Elecraft] KX1 LED

[Don Wilhelm]

Jason,

Not to worry - it has always been that way, and all of them will do that 
too.
The uP lines that drive the LED display are shared with other functions, 
and even after the LED is 'blanked', these other functions will still be 
active and the LED segments will have a bit of a 'glow' to them as a 
result.  If you don't want to see it, then always run the KX1 in a 
lighted room :-) .  Normally that effect can only be seen in the dark 
unless one has very good eyes.

73,
Don W3FPR

Jason Hissong wrote:
> Hey guys,
>
> Quick question... I noticed that after the LED goes out after 
> displaying the frequency, some of the segments are still lit, but very 
> faint.  It does not affect the radio in any way, but I was just 
> curious to why this happens.
>