[Elecraft] K3 Transverter Control Cable

[Don Wilhelm]

Bud,

The transverter cable needs only 3 signal lines plus ground.
AUXBUS  K3 ACC pin 2 to KXVxx pin 6
KEYING   K3 ACC pin 10 to KXVxx pin 9
+12 VDC  K3 +12 volts output to KXVxx pin 8 (other methods can be used. 
but the KXVxx uses this input to sense when the K3 has been turned on).
Ground   K3 ACC pin 5 or 12 to KXVxx pin 1.

That should provide you with a transverter that works with the K3.  If 
it does not work properly, plese let me know.

73,
Don W3FPR

Bud Governale, W3LL wrote:
> I'd like to make up a K3 Transverter control cable.
>
> Which pins of the Elecraft Transverter J6 DB-9 connector 
> are connected to which pins of the K3 AUX I/O?
>   
>