[Elecraft] K3 VCO Errors

[max iw0gxy]

I have almost the same probs on 1118 but mine showed during the synth.
calibration the following errors:
first   E00005   -   ERR VCO
then  E00255   -   ERR VC4
I sent an email to support and waiting a reply.
My K3/100 has firmware 2.02 and it is fitted with 2 opt roofing, KXV3 and
KBPF3 (the KPA100 is not installed yet).
I checked on the reflector but I'm waiting for the "official" reply. I wish
I should not send back any board.

Max IW0GXY
http://www.iw0gxy.it www.iw0gxy.it 


Paul Franson-2 wrote:
> 
> 1114 arrived Friday - all went well until I got to the
> synthesizer 
> calibration.  Getting error after the calibration runs
> for a brief 
> period - first get err VCO 00374 , press menu then get
> err VC4 00039.  
> Book says contact support - sent them an email this
> morning - while I'm 
> waiting does anyone else have any ideas on what to
> check?
> 
> Thanks
> 
> Paul  W2LE
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://www.nabble.com/K3-VCO-Errors-tp18055021p18064323.html
Sent from the Elecraft mailing list archive at Nabble.com.