[Elecraft] 3rd Party K3 Compatibility Question

[Joe Subich, W4TV]

> I didn't mention DXlab because I don't 
> think Dave AA6YQ has added any K3-specific code.

Yes, the K3 is specifically supported.  Dave and I have been 
exchanging e-mail on adding filter support for the K3 (FWxxx; 
command).   Unfortunately there are a few issues ... Dual PB 
filter is only available through the SWH command with no way 
for the control program to know its state,  no way to select 
the 1st IF filter,  and no way to set the center frequency. 

I don't know if it wouldn't be better to wait on documentation 
of the ! and @ commands. 

73, 

   ... Joe, W4TV 
 



> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Simon 
> Brown (HB9DRV)
> Sent: Sunday, June 22, 2008 4:24 AM
> To: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] 3rd Party K3 Compatibility Question
> 
> 
> N4PY's software has K3 support. In fact any code written for 
> the K2 will 
> work with the K3, I didn't mention DXlab because I don't 
> think Dave AA6YQ 
> has added any K3-specific code.
> 
> Simon Brown, HB9DRV
> 
> --------------------------------------------------
> From: "Joe Subich, W4TV" <lists at microham-usa.com>
> 
> >
> > All of the microHAM Interfaces plus microHAM Band Decoder 
> and microHAM 
> > Station Master also DXlab Suite (specifically CI-V 
> Commander the radio 
> > control application but also the entire suite 
> logger/digital ap/etc.).
> >
>