[Elecraft] How to get 100 watt amp enabled?

[Bill Maddock]

You are right I was on the wrong one, but found the PA NOR and turned off
rig and back on - now it's allright - Ignorance is Bliss - I'm learning
My power supply is MFJ 4245MV a 45 amp - I will use til after FD than
I will do perm hookup to Astron 70A. Boy I love how this radio
can cut power back so accurately - very comparable with
my drake W4 wattmeter!

WE ARE ALL Fixed!!

Thanks and 73,

Bill N4ZI


--- On Fri, 6/20/08, Bob Cunnings <bob.cunnings at gmail.com> wrote:

> From: Bob Cunnings <bob.cunnings at gmail.com>
> Subject: Re: [Elecraft] How to get 100 watt amp enabled?
> To: n4zi96 at yahoo.com
> Cc: elecraft at mailman.qth.net
> Date: Friday, June 20, 2008, 11:25 PM
> Are you in PA NOR or in PAIO NOR?
> 
> You need to be in PA NOR to enable high power.
> 
> Bob NW8L
> 
> On Fri, Jun 20, 2008 at 9:01 PM, Bill Maddock
> <n4zi96 at yahoo.com> wrote:
> > I just installed the KPA3 - the fans work in the test
> mode - I let the
> > config in NOR instead of not installed. I am still
> only seeing 12 watts
> > out - running the 1.96 firmware that came with it. I
> set the PA temp
> > according to the sheet - I can not get xmit LP to HP
> for so reason -
> > any ideas - maybe I'm just tired? The fuse leads
> are hooked up.
> >
> > Question #2 I know that you have to configure the
> roofing filter for
> > each mode - Do they need to be configured on each mode
> on every band
> > or just one of the bands to cover for all bands?
> >
> > Anyone got any ideas?
> >
> > Thanks and 73,
> >
> > Bill N4ZI
> >
> >
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >