[Elecraft] K3 noise reduction

[Stephen Prior]

Would it not be a good idea to not allow TxEQ and RxEQ in Data A mode?

Maybe it could be allowed by changing a setting in config if it were desired
to use the equalisers for data but by default it would not.

73 Stephen G4SJP


On 20/06/2008 18:31, "Lyle Johnson" <kk7p at wavecable.com> wrote:

>> Quick question, how about in data mode, there seems to be no nr avaiable
>> then, is this normal ?
> 
> Yes.
> 
> In data mode, the intent is to have as pure a signal as possible, so AN
> and NR are not available.  RxEQ should be set to flat, and if using DATA
> A mode then TxEQ should also be set to flat.
> 
> 73,
> 
> Lyle KK7P
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>