[Elecraft] K3 - REF CAL Question

[Bud Semon N7CW]

Dave and Glenn (ON4WIX),

Thanks - the TECH MD worked.  The errata sheet that came with my Owner's
Manual referred to an update to the REF CAL procedure in a future firmware
update and I assumed that it was included in the latest.  So much for
assuming :)  I'll keep my eyes on the reflector...

73 and CU on the bands.

Bud  N7CW

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dave G4AON
Sent: Monday, June 16, 2008 12:08 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 - REF CAL Question

Bud, this one crops up from time to time, unfortunately Elecraft haven't 
yet implemented the higher stability TCXO calibration routine... So you 
can't calibrate it better than 1ppm.

The technical menu needs to be turned on in order to view the PA temp, etc.

73 Dave, G4AON
K3/100 #80
----------------

I don't seem to be able to get my K3 to go from REF CAL to REF xxC. Tapping
the 1 just changes from A to B. I have the latest firmware and I can't find
anywhere I'm supposed to tell the firmware that I have the 1 ppm oscillator.
Can anyone tell me what I'm missing?
<SNIP>
73, Bud N7CW

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com