[Elecraft] K3: no output on "line out"?

[Joe Subich, W4TV]

Franki, 

Check your connections.  Some of the microHAM K3 cables have 
the Line In/Line Out (PC In/PC Out) plugs mislabeled.  The 
3.5 mm plug with the 3.5 mm female jack (used for subreceiver 
audio) should be connected to the K3 "Line Out" jack. 

73, 

   ... Joe, W4TV 
 

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Franki ON5ZO
> Sent: Sunday, June 15, 2008 8:58 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3: no output on "line out"?
> 
> 
> I am trying to get set up for RTTY with an MK2R+ and 
> N1MMLogger / MMTTY. It seems the line out is dead: I don't 
> get a waterfall on the screen. When I 
> plug the cable from the other radio in the K3's slot on the 
> MK2R+, I get a 
> signal. I tested the cable between rig and interface which 
> seems OK. So my conclusion is: nothing comes out of the LINE 
> OUT. I looked through the 
> manual but only found the LIN OUT level parameter which I 
> cranked up to the 
> max but that doesn't fix it.
> 
> Any ideas? Am I forgetting something?
> - Franki ON5ZO
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com