[Elecraft] Fw: K3 - SSB levels

[Mike Harris]

----- Original Message ----- 
From: "Dave G4AON" <elecraft at astromag.co.uk>
To: <elecraft at mailman.qth.net>
Sent: Saturday, June 14, 2008 5:10 PM
Subject: [Elecraft] Fw: K3 - SSB levels


| Julian
|
| I've noticed a similar odd issue when using the Winlink program
| "Airmail", after quitting the HF module the K3 is returned to it's
| original frequency but with the 6 KHz bandwidth filter instead of the
| 2.8 KHz one... Rather strange as on USB that filter is not enabled.
|
| 73 Dave, G4AON
| K3/100 #80 MCU f/w 2.02, DSP f/w 1.78
| -------------------------------------------------------
|
| Do either of you guys use computer software to control the radio, 
perchance?
| I recently identified a problem where filter settings were not properly
| being stored or restored when changing bands by software command. 
Perhaps
| other settings are getting lost or confused as well.
|
| -----
| Julian, G4ILO K3 s/n: 222 K2 s/n: 392

No, I've got a box with knobs and buttons on and I prefer to twist and 
push them.  Computer is only used for logging.  The only time I use it to 
control the radio is spots and in contests for requested QSYs.

Regards,

Mike VP8NO