[Elecraft] N4PY software for K3 now available

[AA6YQ]

Tom Childers, N5GE wrote:
> 
> On Fri, 6 Jun 2008 12:34:25 -0400, "Joe Subich, W4TV"
> <lists at microham-usa.com>
> wrote:
> 
> I downloaded the DXView Rotor Control portion of it and was disappointed
> to find
> that when entering a US callsign it always gave the same heading
> (somewhere in
> SE USA).  That pretty much makes it unusable for anything but DX call
> signs.
> Entering a 6 digit grid square caused recalculation based on the callsign
> entered, which is another reason for not using it.
> 
> 

DXView is part of the free-ware DXLab Suite, available via
www.dxlabsuite.com .

If you install USAP database into DXView's Databases folder, then entering
any callsign issued by the FCC will produce a location/grid/bearing accurate
to the center of that station's zipcode. The USAP database is freely
available via DXView's row in the "Available Releases" table in
http://www.dxlabsuite.com/download.htm .

Entering a 6-digit grid square in DXView displays the location of that grid
square; the current callsign has no impact the calculation.

      73,

            Dave, AA6YQ

-- 
View this message in context: http://www.nabble.com/N4PY-software-for-K3-now-available-tp17679731p17771516.html
Sent from the Elecraft mailing list archive at Nabble.com.