[Elecraft] K2 build - VCO Test / Alignment issue

[John Hoaglun]

I have entered the Alignment and Test Part II portion of my K2 build.
 
The "PLL reference oscillator range test" seems to check out fine. But when
I run the "VCO test" (which is 80m @ 4000.10khz @ TP1 = 8-10MHz) I am not
seeing much of anything on the frequency counter. (I see readings on TP2 and
TP3 but not TP1.)
 
Any suggestions from others that have seen issues at this step in the check
out process?
 
Thanks, JH
 
-----------------------------
John Hoaglun
NG0R - EN25
http://www.hoaglun.com