SV: [Elecraft] K3: Storing PWR level in memories

[Lennart Michaëlsson]

Jerry/N8BM said:

Might it be a good idea to allow the storage and then recall of the
power level in those memories on a per band basis?  Personally I would
like to store a power level appropriate for driving my amp on each band.
So when I select a particular band via a memory recall I can be
absolutely assured that it is at a specific and known level each and
every time that I use one of the memories.  If my intention is to run
the full 100 watts than I will need to crank the PWR control.  Better
doing that than risk damage to an amp.  The current PWR SET>Per Band
would remain intact.

..and I tend to agree even if -so far- I have not been using any solid state
amps, one of my tube amp:s is a high risk amp while the other one can easily
take 100 W+.
I would appreciate this function if it is possible, Wayne et al.
Len SM7BIC